SBT Oil Pump Block-Off Kit Sea-Doo / Tigershark

SBT Oil Pump Block-Off Kit 36-007
Sea-Doo 787/ 951 Tigershark 640/ 770
Block off kits are ONLY for carbureted applications. It is not possible to pre-mix a fuel injected ski, as the injectors will clog.

• Install the plate with the gasket, o-ring or silicone to seal it (whichever was OE).
• Next, block off the oil feed lines (these are the lines that run from the oil pump to the intake manifold/carbs/flame arrestor). There are a couple ways to do this. First you could leave the lines attached to the manifold, cut the lines and put screws in the end with a cable tie. Second you could use the little block off caps that may come with the plate.
• Remember you just got rid of your oil pump and put oil in the fuel, but you do not have premix fuel in the fuel lines. It's a good idea to squirt some oil down the carburetors then start the watercraft on the flush kit and let it idle for about 15 minutes. This allows the un-mixed fuel to clear the lines.